Aluminum doors widely in the market now, many homes have aluminum door, aluminum door hinge how to positions aluminum door hinge how to install it there must be a lot of people care about it. Small series below to see how aluminum hinge installation and aluminium hinges how to position it. Hoping to help yo.
First observation of hinge types, this step is often not easily noticed, but blindly get hinges installed, and easy to misplace, after installation or drilling required and removed, thus affecting the appearance of the door.
1, watching the door or window opening direction is to the left or right opening.
2, measurement, use a measuring plate or private pencil line location, again with an electric drill or hole punch holes in door panel (requires a choice according to hinge mounting hole size drill bit directly), drilling depth is based on a fixed PIN length.
3, the hinges into the hinge hole on the door panel using self tapping screws securing the hinge. Embedded hinges door will hinge Cup holes open, then set in and align the side panels, the base is fixed with self tapping screws.
4, debug, installation results, look at the hinges of the doors and Windows are installed too tight or too loose or the gap is too wide, and so on, which hinge around, up and down, adjust for best Windows and doors, hinge installation is complete.
1, must measure hinge location, otherwise easily lead to doors or Windows installed crooked, even the hinges cannot be installed at all.
2, hinge drilling depth must not be too deep or too shallow, too deep will easily lead to overly flexible loose, if too much light it’s hard to put in the screws, a little lighter. The size of the hole must not be too large, so easily lead to too loose, impact doors and Windows closed to open, thus affecting the life, smaller does not matter, just screw is relatively difficult. When the screws, do not miss, so as not to affect the use of doors and Windows.
Aluminum door hinge location
A positioning hinge, two hinges 1 and 2 with a rotational component.
Turned component including two hinge seat 1, and 2 between has two group turned tablets 3, and 4, two group turned tablets between through hinge 5 connection; turned tablets 3 of end and hinge seat 1 through hinge 6 connection, turned tablets 3 of another end has positioning Rod 7; turned tablets 4 of end and hinge seat 2 through hinge 8 connection, turned tablets 4 of another end has positioning Rod 9; two hinge seat respectively connection has positioning pieces 10, and 11, positioning pieces 10, and 11 Shang respectively has can capacity positioning Rod 7, and 9 in which sliding of sliding slot 12, Slide positioning card installed in slot 13. Due to positioning the hinge Rod installed in 7, 9, hinges on turns, the rod 7, 9 in the chute slide, when Rod 7, 9 meet card points 13 o’clock, card point Rod card, so hinge location.